Thank you kind sir. I will charge them around 1.1a at 20.5v to be safe. This DC power supply is the most useful electronic thing I've bought haha
Is anyone able to measure the voltage of a fully charged 18v triton / greenlund battery cell?
I'm using a DC power supply to manually charge them...
Thanks for the info.
I think you guys a right a powerbank that recharges and outputs is probably the easiest option..
How do I check which...
- budget - ideally around $50? can stretch to $100.
- dashcam is always recording
- i opted for a capacitor based dashcam for...
Thanks I ended up getting one from tortech.
measured at 103v from 244v mains.
I am wondereing if anything like this exists off the shelf (of it is relatively easy to make).
I have a few powerbanks that I alternate...
Does anyone know of any good quality portable speakers with built in controls on the actual speaker?
It's a mochi maker.
Is there alot of harm in getting a 110 or 120v transformer instead of 100v?
I bought back a kitchen appliance from Japan.
It runs off 100V, 50/60hz.
Can you guys recommend me a reputable transformer or where a...
I am getting into tea and ordered a yixing clay pot.
It is from a semi-reputable source.
The idea of a yixing clay pot is that over time...
Any suggestions for a chinese android? Must have a removable battery and have fast boot/reboot time.
I was always worried about the 'theoretical' in rush current from rebalancing, but you've got me thinking.
How would I run the two battery...
I have thought about it but the main issue was the different voltages and charging characteristics between a lead acid starter and the LiFePO4...
Thanks for your reply.
I bought 4x 3.2V 200Ah LiFePO4 cells last year to make up 12v for use as a secondary battery.
I dont need it for that...
Whats the best way for me to get a high efficiency (90%+) step up DC to DC transformer to go from 3.2V to 5V?
It is for a 3.2V LiFePO4...
Any recommendations for dan dan noodles in Sydney?
I'm after the type with the chilli oil, sesame oil/paste and pork mince at the bottom with...
They put good looking birds on the till.
i've pulled the trigger and ordered the ANET a8.
Can anyone recommend me a filament for use to make a plastic trim piece in a car?
Thanks for the info Rob.
Maybe the tracer gas smell detection would be a good option :).