3D Printed TOY NERF Blasters

Still tweaking but it seems to be working.

Edit: The colour scheme isn't the greatest but that's ok.

EDIT 2: I swapped out the handguard pictured with one that has M-LOK slots so I can get rail covers or use M-LOK attachments.

Also, the handguard below doesn't offer easy access to the battery terminals. It seems you need to take off the handguard - upper receiver combo to get access.

 

MOAB kit pre-launch

https://moab-kit.gatlingtommy.com/

 

yeah i am gonna pass on that one

 

So the buffer tube that comes with the latest blaster build is a 2-piece that doesn't allow for batteries to be placed in the buffer tube itself, so I modded one and that should make it easier to load batteries.

 

Been watching that guy for ages now

 

A mild stone! for me anyways... my first fully printed ABS blaster with my TPU Hybrid Core

 

Reprinting some parts since I am not liking the colour scheme i had initially printed the parts in.

Also means I now try sunlu PLA+.

 

Another mild stone but full ASA this time!!!!!

 

Decided to redo the hildolfr in a nice black/green/neon green/gray colour scheme and rewired the battery to be stored in the buttstock/buffer tube instead of the handguard. I had to make a modded buffer tube as the one provided was in 2 parts and it didn't have the cavity that airsoft buffer tubes have. Plus the thread pitch was different. So I mashes the threaded end from the Hildolfr and the tube end from an AEG buffer tube and it worked.

It does mean I can't run with the PDW stock and that's fine.

 

Would strongly recommend replacing the Worker Hurricane wheels with Pulsar wheels. Better performance and more accurate.

 

https://www.blastertech.com.au/-Pulsar_Flywheels/p2928293_21715593.aspx
???????????????????? dis juan?

 

Yeah. They are have a higher concavity than the worker wheels and the canted ridges on the worker wheels don't really work as intended.

 

A flywheel accurate

 

Hmm.... How to get the worker hurricane flywheels off?

 

Was thinking last night about modding the Foxbat for an upcoming event! i seen Parralax and after a look at the BOM i realised i had all the bits already for this one.

An amazing little twist on sillys foxbat... this is a lotta fun , shoots around 220 with an extreme short easy side prime.. I am looking to get it down to 150 so a bit of spring work to come

 

If theres one flywheel i would like to see in RL it would be a stinger v2

 

one of my 3S 11.1v batteries had one of their wires cut at the connector end, so I had to do a quick resolder of a replacement XT30 connector.

 

Oh good some screws arrived. I can finally make my BCARs.

 

I was going to print the Ontos but I think this might be a good one (and slightly more space efficient) for my first go at 3D printing a blaster.

 

Good luck.