Logitech Z906 speaker connections

Discussion in 'PC Audio' started by TheWedgie, Aug 7, 2017.

  1. TheWedgie

    TheWedgie Salty

    Joined:
    Jun 16, 2002
    Messages:
    2,756
    Location:
    South Australia
    Howdy - so I've got the speakers for the Z906 wired up in the carport/entertaining area for a projector screen, but have not been leaving the sub/amp bit out there due to dust.

    Currently it's just bare wires connecting from the speakers, but it's proving to be a pain to connect and disconnect each time.

    After any suggestions as to a better solution - I'd thought about some of these, or perhaps putting a short lead with RCA female sockets to the back of the sub, and male on the end of the speaker wires...
     
  2. MUTMAN

    MUTMAN Member

    Joined:
    Jun 27, 2001
    Messages:
    4,640
    Location:
    4109
  3. OP
    OP
    TheWedgie

    TheWedgie Salty

    Joined:
    Jun 16, 2002
    Messages:
    2,756
    Location:
    South Australia
  4. MUTMAN

    MUTMAN Member

    Joined:
    Jun 27, 2001
    Messages:
    4,640
    Location:
    4109
    i used to have a similar setup and used those. be warned, they are not going top fall apart easily. the connections dry out and need a little electrical grease to keep them moving smoothly
    vaseline works well :Paranoid:
     

Share This Page